easy-guard - fire upgrade coating - Class "0"

General Specification:

1. Attend site and carry out adhesion tests to
pre-painted wall and ceiling surfaces.

2. Identify any areas of weak inter-coat
adhesion and scrape back to a hard edge.

3. Feather off as necessary.

4. Thoroughly abrade all glossy/hard surfaces
down and degrease with easy-guard Wash
Down Agent and rinse with clean water.

5. To clean dry surfaces apply 1 coat of easyguard
Class “0” Bond Primer by brush/
roller at a coverage rate of 14-16m²/litre
Allow at least 1 hour drying time.

6. Apply 1 coat of easy-guard Class “0”
Barrier Compound by brush/roller at a
coverage rate of 0.45m2/litre. Pattern as
necessary and lace down when hard dry.

7. Apply 1 coat of easy-guard Class “0”
Colour Coat by brush/roller at a coverage
rate of 6-12 m²/litre. Allow at least 8
hours drying time.

8 Provide Contract Administrator with Fire
Test Certificates demonstrating Class “0”
performance over the Warrington “Blue”
Board in full accordance with the
Warrington Application Monitoring
Procedure.

easy guard - flame resistant paint - Class "1"

General Specification:

1. Attend site and carry out adhesion
tests to all pre-painted wall and
ceiling surfaces.

2. Identify any areas of weak intercoat
adhesion and scrape back to a
hard edge.

3. Feather off as necessary and fill
using a high quality filling
compound.

4. Thoroughly abrade all glossy/hard
surfaces. Wash down and degrease
with easy-guard Wash Down Agent
and rinse with clean water.

5. Spot prime any bare or filled
patches with 1 coat of easy-guard
Fire Upgrading Primer thinned
10% with clean water.

6. Apply 1 full coat of easy-guard Fire
Upgrading Primer by brush/roller
at a coverage rate of 8.0m²/litre.
Allow 24 hours drying time.

7. Apply 1 full coat of easy-guard Fire
Upgrading Colour Coat by brush/
roller at a coverage rate of 8.0m²/
litre. Allow at least 24 hours drying
time.